G-FENCE APPLICATION : Using PORTALIS as a G-FENCE system accessory
INNOVATION : Wireless, solar energy, no civil engineering
HIGH PERFORMANCE : Beams multiplexed through optical synchronisation
PORTALIS, is an infrared solar barrier that is connected to a G-FENCE system in order to fulfil perimeter detection of gates. Creating an immaterial and impassable wall of detection, with five dual-beam cells at a height of 2.5 m or 3 m depending on the gate to be protected.
Beams are multiplexed through optical synchronisation, can be set-up in single or dual detection mode and adjustable in height. PORTALIS also has four alarm information modes: intrusion, anti-climbing cap, tamper, disqualification (technical alarm).
Maximum range outdoors
|Height and type of columns||2,5 m single face - 3 m single face|
|Column references||Ref. 30624010 - Ref. 30624110|
|Infrared beams||10 (five dual-beam cells)|
|Lightning strike protector and anti-climbing cap||Integrated|
|Alarm outputs||- RL1 : Intrusion / anti-climbing cap (Rx and Tx) - RL2: Disqualification / tamper(Rx)|
|Power supply||Solar panel and battery in each column|
|Operating temperature||-35°C to +70°C|
|Electromagnetic compatibility||Compliant with European standards (EC label)|
To use the barriers correctly, it is important to ensure that the barrier is not installed on an unstable support (e.g. badly sealed pole, etc.). Before installing an infrared barrier, check that the ground is quite level and will guarantee the stability of the columns with time. A maximum of 10° elevation may be tolerated between the columns. In case of elevation above 10°, contact SORHEA’s sales department.
Check that no vegetation can block the beams, no matter the season and weather condition (wind).
It is also important to check the cleanliness of the covers: it is important to clean them with a soft and damp cloth at least once a year.
This technology works at a wavelength above that of visible light (950nm), which makes the IR beam invisible to the naked eye.
The infrared beams are transmitted and received by infrared cells. The transmitter cellsgenerate a pulsed beam that is sent towards the receiver cellswhich capture the infrared pulses and transform them into electrical signals. In the absence or variation of the signal (loss of 95% of the transmitted signal), an intrusion alarm is triggered. To prevent the receiver cells from being interfered with by the transmitted infrared beams thecells are multiplexed.
This principle consists in transmitting an infrared pulse in a synchronised manner, via an optical or wired link between the transmitter and receiver columns. This feature is also used to optimize the alignment of the cells (“alignment feedback”). All the SORHEA IR barriers are multiplexed (except UNIRIS II & BIRIS II).